Table of Contents
Advertisement
Chapter 2 Preparations
5.
Insert the backup device into chassis.
Do not push the backup device in completely as the
cable has to be connected to the device.
6.
Connect the interface cable and power cable to the installed 3.5-inch backup device.
For more information, see Chapter 2 (1.16 Connecting Cables).
7.
Push the device all the way until it clicks, indicating that it is locked.
8.
Assemble the server.
9.
Install device drivers for installed backup device as needed.
For more information, refer to the manual provided with the backup device.
Removal
You can remove the backup device by reversing the installation procedure. If the devices are to remain
removed, attach the stored dummy cover.
78
Note
Arrange the unused power supply cable at the rear of the backup device so that this
cable comes between the HDD cage and optical disk drive. Be careful not to apply
a force to the I/F cable connector when pushing in the backup device.
Express5800/T110j User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
