Table of Contents
Advertisement
Chapter 2 Preparations
Connecting the flash backup unit control cable
To connect the flash backup unit control cable into the battery pack, see the following figure. Check the
form of the connector and connect the cable straight into the connector.
Getting ready to install the battery
1.
See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
To remove the side cover, see Chapter 2 (1.3 Removing the Side Cover).
Installing the flash backup unit
Install the flash backup unit to this server with one screw and fixing bracket provided with the flash
backup unit.
Connecting to a RAID controller
1.
Connect another connector of the flash backup unit control cable to the RAID controller. Check
the marker of the connector and connect the cable straight into the connector. Be careful not to
press it in at an angle when connecting.
Important
Make sure that the battery bracket is correctly attached to the server.
Express5800/T110j User's Guide
1. Installing Internal Optional Devices
47
Advertisement
Table of Contents
