Table of Contents
Advertisement
Chapter 2 Preparations
Install a 2.5-inch HDD cage and hard disk drives in the server by using the following procedure.
1.
See steps 1 to 3 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
3.
Insert the HDD cage into the HDD bay. The "TOP"
must face rightward.
4.
Attach the HDD cage by using the four screws.
5.
Connect the interface cables and power cable to the backplane board installed in the HDD cage.
Use the interface cables that come with the HDD cage. For details about cable connection, see
Chapter 2 (1.16 Connecting Cables).
6.
Reassemble the server.
7.
Remove the dummy tray from the HDD cage.
72
Important
Keep the dummy trays for future use.
Keep the dummy trays installed in slots where hard disk drives are not
installed.
Express5800/T110j User's Guide
1. Installing Internal Optional Devices
The "TOP"
must face
rightward.
Advertisement
Table of Contents
