Attaching A Sign Plate Label - Huawei RRU3931E Installation Manual

RRU3931E
Installation Guide
Label Structure
Figure 1-62
Figure 1-62 Label structure

1.11.6 Attaching a Sign Plate Label

This section describes the procedures and precautions for attaching a sign plate label.
Context
l
l
Procedure
Step 1 Lead the cable ties through the holes of a label, and then bind the label to the cable, as shown
in Figure
direction.
Figure 1-63 Binding the label
Issue Draft A (2016-03-30)
NOTE
l In the label content, Small Cell identifies a Huawei micro base station.
l For a single base station, only labels with Small Cell or Small Cell0 are used.
l For two base stations at the same site: If UMTS and LTE base stations are located at the same site,
you are advised to label the UMTS base station as Small Cell0 and the LTE base station as Small
Cell1. If two base stations work in the same mode, label the one directly connected to external
devices as Small Cell0 and the cascaded one as Small Cell1.
shows the structure of a Small Cell engineering label.
This section applies to Huawei sign plate labels. If other engineering labels in
accordance with local standards are used on site, follow the local standards for attaching
sign plate labels.
A sign plate label is usually used for a power cable, ground label, signal cable, and
antenna. This section uses
1-63. Ensure that the cable ties are led through the holes of the label in the same
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1.11.5 Small Cell Engineering Label
1 RRU3931E Installation Guide
as an example.
57