Mounting On Linear Actuators - ABB TZIDC Operating Instructions Manual

TZIDC DIGITAL POSITIONER | OI/TZIDC-EN REV. B

Mounting on linear actuators

For mounting on a linear actuator in accordance with DIN / IEC
534 (lateral mounting as per NAMUR), the following attachment
kit is available:
9
8
7
j
k
l
m
1 Screw
2 Washer
3 Mounting bracket
4 Lever with follower pin
(for mechanical stroke
10 to 35 mm [0.39 to 1.38 in] or
20 to 100 mm [0.79 to 3.94 in])
5 Washers
6 Screws
Figure 7: Attachment kit
1
2
3
5
6
4
M10413-01
7 U-bolts
8 Washers
9 Nuts
j Screws
k Spring washers
l Clamp plates
m Follower guide
1
2
3
4
Figure 8: Attaching a follower guide to the actuator
1. Tighten the screws so that they are hand-tight.
2. Attach the follower guide
screws and spring washers
4
1 2 3
7
6
Figure 9: Mounting lever and bracket on the positioner
1. Attach the lever to the feedback shaft
6
positioner (can only be mounted in one position due to the
cut shape of the feedback shaft).
2. Using the arrow marks
4
within the operating range (between the arrows).
3. Hand-tighten the screw
M10411-01
and clamp plates with
1 2
to the actuator stem.
3
5 4
of the
5
, check whether the lever moves
on the lever.
7
17
M10409-01