Table of Contents
Advertisement
Adding parameters to the input and output tables can be achieved only through the proprietary software
package 'iTools', running on a PC. It cannot be configured through the user interface. The following description
assumes that the user is familiar with 'iTools'. Section 9 of this manual shows how to set up an iTools link to the
unit and the iTools on-line help system and its PDF version (HA028838) should be referred-to as necessary.
Note: The client/server and the PC must all be on the same network.
Once iTools has started up and the 'Scan' process has 'found' the relevant instrument,
the scan process should be stopped and the instrument (s) allowed to synchronize.
(The scan may be left to run its course, but the speed at which iTools operates is
reduced for the duration of the scan process.)
EXAMPLE
To add Loop 2 Setpoint 2 to Output 4 of the Client Output table.
In the example shown below, the instruments have both synchronized, and the
'Access' tool button clicked-on for both instruments to set them into configuration
mode.
With the client selected, expand the EtherNet/IP folder in the Browse list, then
double-click on the 'ImplicitOutputs' folder.
Locate and expand the Loop 2 SP folder in the Browse window, and click-drag
SP2 to 'Output 4' and release.
A
September 18
FEC920: USER GUIDE
Figure 29 Dragging a parameter to the Output table
A5E45696052A Rev-AA
Synchronized
Not synchronized
Page 39
Advertisement
Table of Contents
