NEC Express5800/T120h User Manual page 119

Chapter 2 Preparations
5. Lift straight up the blank cover on the slot where the PCI board will be installed, and remove it.
6. Fit the PCI slot to PCI card terminal, then insert the terminal into the connector firmly.
7. Connect the required internal and external cables to the PCI card. Refer to the documentation that came
with the PCI card.
Important Do not touch the terminal part of riser card or PCI card and the signal pins of
electric parts installed on the board. Installing boards with dirt or oil can
cause malfunction.
Note Make sure that the edge of a PCI card bracket is seated into the fixed slot of

the riser card.
 Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.
 If you have trouble installing the card, remove the card once and try again. If
you apply excessive pressure on the card, a PCI card or riser card might break.
Express5800/T120h User's Guide
1. Installing Internal Optional Devices
119