Lockout/Tag Out Procedure
Lockout/Tag Out Procedure
To power OFF the spectrometer follow this procedure:
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
10
Close the software.
Power OFF the computer holding the software.
Set the ON/OFF power switch of the spectrometer power supply to OFF.
If applicable, set the ON/OFF power switch of the accessory to OFF.
If applicable, disconnect the accessory power connector from the wall outlet.
Disconnect the Ethernet Cable from the spectrometer.
Disconnect the spectrometer power connector from the wall outlet.
Section 2 Safety Summary
AA003700-01 rev. G. 2.0