Connector Location; Ethernet Cables; Private Connection; Connection Through A Network - ABB MB3000 Series Installation And User Manual

Connector Location

Connector Location
There are only 3 connectors on the MB3000 Series FTIR spectrometer and 1 power
switch on the power supply.
All 3 connectors are located at the rear of the MB3000 Series FTIR spectrometer.
Power
connector
Purge
port
Ethernet
port

Ethernet Cables

Two Ethernet cables are supplied with the MB3000 Series FTIR spectrometer
depending on the type of connection you need. Be sure to use the correct type of
cable. Both connectors connect into the Ethernet Port of the spectrometer located at
the rear of the spectrometer.

Private connection

A private (direct) connection from the spectrometer to the computer requires a
crossover cable.

Connection through a Network

A connection from the spectrometer to a local area Network requires a straight pin
cable.
26
Figure 6- 1 : Connector location
Section 6 Product Overview
Power supply
AA003700-01 rev. G. 2.0