To A Network - ABB MB3000 Series Installation And User Manual

To a Network

To a Network
In this setup, both the PC and the instrument will obtain their LAN configuration
from the control DHCP server.
When first turned ON, your spectrometer will attempt to obtain automatically its
LAN configuration from the DHCP server.
To ensure the DHCP server is properly detected, perform a power OFF/ON cycle
after connecting properly the Ethernet cable (i.e. Network LED must be ON).
To insure your PC Ethernet interface uses the DHCP server, perform the following
procedure:
AA003700-01 rev. G. 2.0
Figure 4- 1. Connection via a Network
Section 4 Connections
18