ABB MB3000 Series Installation And User Manual page 46

LED troubleshooting table
.
LED
Power
Status
40
State Possible cause
OFF Power switch not ON
Power cable not connected
No current at Power outlet
Internal problems
GREEN Normal operation
RED
No detector connected
blinking
GREEN
with Red Operation Error
short blinks
RED Internal Error
OFF System is loading
System is initializing or
performing calibration.
GREEN
The initialization sequence is
Blinking
performed at startup or after a
Table- 9- 1. LED Troubleshooting table
perturbation.
Section 9 Troubleshooting
Solution
Turn power switch ON. Refer to
Connector Location
Make sure the power cable is
connected in the Spectrometer and in
the wall outlet. Refer to
Location on page 26
Test outlet for voltage.
Contact ABB. Refer to the back cover
of this document
Replace or install detector module.
Refer to Detector Module
Replacement on page 29.
Check software health monitoring.
Check software health monitoring.
If after 1 min. LED is still OFF, check
software health monitoring
If this sequence last longer than 5
minutes, it is probably caused by a
low laser or white light level
Contact ABB. Refer to the back cover
of this document.
AA003700-01 rev. G. 2.0
on page 26.
Connector