Maintenance Switch (Maint); Node No. Setting Switches - Toshiba G3 Instruction Manual

3.1.2

Maintenance switch (MAINT)

Figure 3-2 shows the configuration of the maintenance switch.
The maintenance switch is used for restarting GA932 module.
Tilt the switch to the upper side (MAINT) and then return it to the lower
side (RUN) when restart the module.
Important
• While GA932 is being energized, do not insert or remove the module.
Note
• Use a precision screwdriver for setting the maintenance switch.
• The maintenance switch is factory-set to the upper side (MAINT).
3.1.3

Node No. setting switches

Table 3-2 Node setting switch setting
Name
STN-H Set the Node No. (Higher digit address) of TC-net I/O Loop.
STN-L Set the Node No. (Lower digit address) of TC-net I/O Loop.
Note
• Node No. can be set between 3 ～14 (03h ～ 0Eh). Please do not set any other value.
[Example] When set STN-H to 0 and STN-L to A, the Node No. will be 10 (0Ah)
• Please do not overlap the Node No. with the other device on the TC-net I/O loop when building a
system.
• Please turn on the power again, or restart with the maintenance switch when the Node No.
setting is changed.
↓RUN
Figure 3-2 Maintenance switch
F
Figure 3-3 Node setting switch
Description
Unified Controller nv series G3 I/O Adapter GA932 Module Instruction Manual
MAINT
3.1 Switch Setting
Remark
Factory-set to 00h
23