Front View (Without Front Bezel) - NEC Express5800/R120g-2M User Manual

Chapter 1 General Description
4.2

Front View (Without Front Bezel)

(8)-1 (8)-2
(9)-1 (9)-3
(9)-0 (9)-2
(8) DISK LED
LEDs for showing the hard disk status.
The LED provided for each HDD.
(See page 34)
(9) 2.5-inch Hard Disk Drive Bay
Bays for installing HDDs. The sequential numbers indicate
the corresponding slot numbers. All bays include Dummy
Trays.
(10) USB Connectors (front)
Connectors for connecting USB interface devices.
(11) RESET Switch
A switch for resetting the server.
(12) DUMP Switch (NMI)
A switch for collecting the memory dump.
(13) BMC RESET Switch
A switch for resetting BMC of the server. Use this switch
only when there is a problem with EXPRESSSCOPE
Engine 3 (BMC). To use this switch, press it at least five
seconds.
(14) POWER Switch/LED
A switch for turning on/off the server. Press once to turn on
the server. POWER LED lights when it is on. Press it again
to turn off the server. Hold down the switch for four seconds
or more to forcibly turn off the server.
(See page 31)
(14) (15)
(9)-5 (9)-7
(18)
(9)-4 (9)-6
Express5800/R120g-2M User's Guide
(11) (12) (13)
See (3) to (5) on previous page.
(10)
(19)
(15) Unit ID (UID) Switch/LED
A switch for turning on/off UID LED.
Pressing the switch once turns on UID LED and pressing
again turns off the LED.
Commands from the software also cause it to turn on or
flash. (See page 33)
(16) Display Connector *1
A connector for connecting a display. This connector
cannot be used with the display connector on rear panel at
the same time.
(17) Pull-out Tab
A tab for showing the model number and serial number of
the server.
(18) 2.5-inch Additional HDD Cage Bay
A bay for installing N8154-68 2.5-inch HDD cage.
(19) Additional Bay (for file backup unit)
A bay for installing an optional RDX drive.
(20) Optical Disk Drive Bay
A bay for installing an optical disk drive.
Either of the following drive can be installed.
– DVD-ROM drive
– DVD SuperMULTI drive
*1 The tray of optical disk drive cannot open depending on the
connector of display cable. Disconnect the display cable
and then open/close the tray.
4. Names and Functions of Parts
(16)
(17)
(20)
25