Configuring The Station - ABB RMC-100 Startup Manual

6.2

Configuring the station

To configure the station:
1. At the PCCU32 Entry screen, click the station ID name in the top node of the
navigation tree. The Station Setup tab displays.
2. Set up the basic settings identified in Table 14.
Entry Format
Station 10 digit
ID alphanumeric
24 digit
Location
alphanumeric
MM/DD/YYYY
Date/
HH:MM:SS
Time
(24 hour clock)
3. Verify the Lithium Battery Status is OK in a green bar (Figure 14). If the status is
Low Voltage or Not Connected, the field background color is red. Refer to
Troubleshooting in the RMC100 User Manual to determine and resolve the
problem before continuing with the startup instructions.
4. Change any other settings in the Station Setup tab as needed. Leave PCCU
open on the Station Setup tab. For more information, refer to the RMC User
Manual.
Table 14: Required Station setup
Description
The station identifier code uniquely identifies each station. If
running a multiple tube station, the station ID is the same for
all tubes on the RMC. If left blank on a single tube device,
the station ID will be the same as the device ID.
The location identifier describes the location, such as the
county name or a road number. Not mandatory.
Date and time must be set correctly and should agree with
the collection equipment if measurement tubes are
instantiated.
Figure 14: Station Setup screen
2105551-001 rev. AC | 21