ABB RMC-100 Startup Manual page 22

6.3 Configuring security (optional)
Configuring the security is optional. To configure the security settings:
1. Ensure that the security switch is set to off. The switch is located between the
TFIO A and TFIO B connectors on the RMC (Figure 15).
2. Return to the PCCU32 Station Setup tab.
3. Verify the Security Switch Status field shows off (Figure 14, Station Setup
screen). The security codes cannot be configured if the status is on.
4. Type a four digit security code for Security Code Level 1 (read only access).
5. Type a four digit security code for Security Code Level 2 (read and write
access).
IMPORTANT NOTE: Take note of the security codes typed. Once
saved, they are not visible on the Station Setup tab.
6. Click Send.
7. Set the RMC security switch to ON.
8. Click Re-read and check that the security switch status is on to begin
enforcement of the security codes.
IMPORTANT NOTE: The codes will be required the next time PCCU32
attempts to connect to the RMC.
9. Call the ABB main office number listed on the back page of this guide if you
need further assistance with security.
22 | 2105551-001 rev. AC
RESET LITH SECUR.
BAT
Figure 15: Security switch
TFIO Cover
Lift cover to
access settings
Security Switch