Assembly and setting up
WARNING! RISK OF FIRE!
►
Never place the appliance underneath wall
cupboards or next to curtains, cupboard
walls or other flammable objects .
►
Set up the appliance at least 70 cm from any
flammable materials (e .g . curtains) .
►
Always place the appliance on a heat-resistant
surface .
►
Set up the appliance with its rear side directly
against the wall . When doing so, ensure that
the wall is made of heat-resistant material
and that the lid 3 can open fully .
1) Remove all of the parts from the box and
remove the packaging material and any
protective film .
2) Clean all components as described in Chapter
"Cleaning and care" . Ensure that all parts are
completely dry .
3) Place the appliance on a heat-resistant, clean
and level surface .
4) Place the drip tray 6 in the frame 5 so that
it sits in the recess to the left of the centre .
ATTENTION! DAMAGE TO PROPERTY!
►
Never use the appliance without the drip
tray 6! Otherwise hot fat and other hot
liquids will drip down from the appliance
onto the surface below .
5) Place the griddle 1 onto the frame 5 .
Ensure that the socket 2 is on the right side .
The griddle 1 must sit correctly in the frame
otherwise the thermostat 9 cannot be con-
nected to the socket 2 .
6) Push the hinges of the lid 3 into the recess on
the frame 5 and close the lid 3 .
■
6
│
GB │ IE │ NI │ CY
7) Connect the thermostat 9 with the socket 2
on the appliance . Ensure that the thermostat 9 is
pushed up to the stop in the socket 2 . Otherwise
the appliance cannot heat up!
Before first use
1) Open the lid 3 by pushing up the catch on
the handle 7 and, at the same time, pulling
the lid 3 upwards .
Open the lid 3 until the hinges slide down
into the hinge guides 4 and the lid 3 is firmly
in place .
2) Wipe the griddle 1 with a moist cloth .
3) Close the lid 3 by lifting it lightly into the
hinge guide 4 so that it can be folded shut .
4) Insert the plug in a mains power socket and
set the temperature control 8 to level 5 . The
appliance will heat up .
5) Wait for 10 minutes .
6) Then disconnect the plug and allow the appli-
ance to cool down .
NOTE
►
The first time the appliance heats up, a small
amount of smoke and smell may be generated
due to production-related residues . This is
completely normal and is not dangerous .
Provide sufficient ventilation by opening a
window, for example .
7) Wipe the griddle 1 with a damp cloth after
cooling .
8) Clean the drip tray 6 as described in Chapter
"Cleaning and care" .
9) Ensure that all parts are completely dry before
operating the appliance .
The appliance is now ready for use .
STGG 1800 A2