Table of Contents
Advertisement
CNFG and ENV Commands
If the board has a secondary SCSI controller, this number is the secondary SCSI ID or address.
For the CPCI-6020, all PCI add-on SCSI controllers/adapters supported by PPCBug are set to
the SCSI ID value entered here.
NVRAM Bootlist (GEV.fw-boot-path) Boot Enable [Y/N] = N?
Y
Give boot priority to devices defined in the fw-boot-path global environment variable
(GEV).
N
Do not give boot priority to devices listed in the fw-boot-path GEV. (Default)
When enabled, the GEV (Global Environment Variable) boot takes priority over all other boots,
including Autoboot and Network Boot.
NVRAM Bootlist(GEV.fw-boot-path) Boot at power-up only [Y/N]=N?
Y
Give boot priority to devices defined in the fw-boot-path GEV at power-up reset only.
N
Give power-up boot priority to devices listed in the fw-boot-path GEV at any reset.
(Default)
NVRAM Bootlist (GEV.fw-boot-path) Boot Abort Delay = 5?
The time in seconds that a boot from the NVRAM boot list will delay before starting the boot.
The purpose for the delay is to allow you the option of stopping the boot by use of the BREAK
key. The time value is from 0-255 seconds. (Default = 5 seconds)
Auto Boot Enable [Y/N] = N?
Y
The Autoboot function is enabled.
N
The Autoboot function is disabled. (Default)
Auto Boot at power-up only [Y/N] = N?
Y
Autoboot is attempted at power-up reset only.
N
Autoboot is attempted at any reset. (Default)
Auto Boot Scan Enable [Y/N] = Y?
Y
If Autoboot is enabled, the Autoboot process attempts to boot from devices specified in
the scan list (e.g., FDISK/CDROM/TAPE/HDISK). (Default)
N
If Autoboot is enabled, the Autoboot process uses the Controller LUN and Device LUN
to boot.
Auto Boot Scan Device Type List = FDISK/CDROM/TAPE/HDISK?
154
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Configuring the PPCBug Parameters
Advertisement
Table of Contents
