Motorola CPCI-6020 Installation And Use Manual page 157

CNFG and ENV Commands
The last location tested when PPCBug searches for a ROMboot module. (Default =
$FFFFFFFC)
Network Auto Boot Enable [Y/N] = N?
Y The Network Auto Boot (NETboot) function is enabled.
N The NETboot function is disabled. (Default)
Network Auto Boot at power-up only [Y/N] = N?
Y NETboot is attempted at power-up reset only.
N NETboot is attempted at any reset. (Default)
Network Auto Boot Controller LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing of network controller
modules currently supported by PPCBug. (Default = $00)
Network Auto Boot Failover Controller LUN = 00?
If set to zero ($00), there will be a second attempt at network boot using the failover Ethernet
controller. If set to non-zero, an attempt is made to use this device to download the same
information that was to be downloaded using the primary Ethernet controller. The failover takes
place when the primary reports a hard error. Refer to the PPCBug Firmware Package User's
Manual for a listing of network controller modules currently supported b the PPCBug.
Network Auto Boot Device LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing of network controller
modules currently supported by PPCBug. (Default = $00)
Network Auto Boot Abort Delay = 5?
The time in seconds that the NETboot sequence will delay before starting the boot. The
purpose for the delay is to allow you the option of stopping the boot by use of the BREAK key.
The time value is from 0-255 seconds. (Default = 5 seconds)
Network Auto Boot Configuration Parameters Offset (NVRAM) = 00001000?
156
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Configuring the PPCBug Parameters