Motorola CPCI-6020 Installation And Use Manual page 53

Compactpci single board computer

Table of Contents

Hardware Preparation and Installation

Refer to the following illustration and perform these steps when installing modules. Note that

this illustration is for general reference only and may not accurately depict the connectors and

handles on the board you are installing.

Stage 1

1. Open the injector levers on your board (see

Lever Types on page

2. Verify the proper slot for the module you are inserting (see

page

50). Align the edges of the module with the card cage rail guides in the

appropriate slot. Insert the board by holding the injector levers, do not exert

unnecessary pressure on the face plate.

3. Using your thumbs, apply equal and steady pressure as necessary to carefully slide

the module into the card cage rail guides (Stage 1). Continue to gently push until the

prealignment guide pegs engage with the backplane connector (Stage 2) and the

injector levers make contact with the chassis rails. Do not force the board into the

backplane slot.

4. Use the injector levers to seat the module in the slot by closing the levers until they

latch into the locked position (Stage 3). If the levers do not completely latch, remove

the module from the chassis and visually inspect the slot to ensure there are no bent

pins.

5. When the module you are installing is completely latched, secure it by tightening the

captive screws at both ends of the face plate.

This section describes a recommended procedure for removing a board module from a chassis.

CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Stage 2

(Detail)

Stage 2

Recognize Different Injector/Ejector

49).

Installing and Removing a Module

Stage 3

Verify Slot Usage on

Table of Contents