Table of Contents
Advertisement
Before You Install or Remove a Board
4. Slide the CompactFlash memory card into the J15 connector and make sure that
pin 1 of the card aligns with pin 1 of J15.
5. If you are installing RAM500 memory cards or a PMC module on this board, follow
the installation instructions in
page 117
and
then reinstall the CPCI-6020 assembly in the proper card slot. Check that the board
is properly seated in the backplane connectors. Take care not to damage or bend
connector pins.
2.12
Before You Install or Remove a Board
Boards may be damaged if improperly installed or handled. Please read and follow the
guidelines in this section to protect your equipment.
Damage of Circuits
Electrostatic discharge and incorrect board installation and removal can damage
circuits or shorten their life
Before touching the board or electronic components make sure that you are working
in an ESD-safe environment.
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 6, RAM500 Memory Expansion Module, on
PMC Module Installation on page
Hardware Preparation and Installation
Insert CompactFlash
44. If not, read the next section nad
47
Advertisement
Table of Contents
