Jumper Settings; Flash Bank Selection; Figure 2-1 Header Locations And Jumper Settings - Motorola CPCI-6020 Installation And Use Manual

Jumper Settings

Remote switch (J19)
Jumpers J7 and J25 are only for factory use
Figure 2-1 Header Locations and Jumper Settings
2.8 Jumper Settings
The following sections describe the on-board jumpers and their configurations for the CPCI-
6020. For jumper locations, see
2.8.1

Flash Bank Selection

The CPCI-6020 contains one bank of 32 MB 16-bit flash memory soldered on-board (Bank A)
and 1 MB of 16-bit socketed flash memory (Bank B). Bank A is 64-bits wide and Bank B is 16-
bits wide. Bank B contains the on-board debugger and diagnostics, PPCBug.
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
U18
U19
U31
Figure 2-1.
Hardware Preparation and Installation
J18
J19
J17
J21
J20
1 3
J24
J22
41