Siemens SIMATIC S7-1500R/H Getting Started page 34

Setting devices IP addresses for the HMI connections
Change the IP addresses of the PROFINET interfaces of the HMI devices and the CPUs for
the PROFINET subnets 2 and 3 (PN/IE_2/3).
1. Select the respective PROFINET interface of the device in the network view.
2. Change the IP address into a valid one in the subnet in the properties in the "Ethernet
addresses" area.
Figure 2-14 IP address for HMI connection to "HMI left" changed
The table below shows all the IP addresses used for the example:
Table 2- 1
PROFINET interface
PG/PC
X1 at CPU left
X1 at CPU right
at ET 200SP "section 1"
at ET 200SP "section 2"
at ET 200SP "section 3"
X2 at CPU left
X1 at HMI left
X2 at CPU right
X1 at HMI right
S7-1500R/H redundant system
Getting Started, 10/2018, A5E44910930-AA
IP addresses used in the example
Subnet IP address
PN/IE1 192.168.0.50
PN/IE1 192.168.0.1
PN/IE1 192.168.0.2
PN/IE1 192.168.0.3
PN/IE1 192.168.0.4
PN/IE1 192.168.0.5
PN/IE_2 192.168.2.1
PN/IE_2 192.168.2.2
PN/IE_3 192.168.3.1
PN/IE_3 192.168.3.2
Configuration
2.4 Configuring HMI devices
33