Section 6
LHMI engineering
118
4.
Place the junction points.
5.
Connect the symbols where necessary by drawing lines between the symbols'
source and destination ports.
GUID-543D7A1C-7DC8-493B-BFE6-1803505A2F26 V1 EN
Figure 98:
Adding symbols to an SLD page
6.
In the Object Properties pane, set the symbol properties.
•
Use the x and y coordinates to adjust the placement of symbols in the
single-line diagram.
•
Use controlState to define the default state of the symbol to be displayed
in the view.
•
Use indicationOnly to define if the symbol is controllable (true = status
only; false = controllable).
•
Use control to link the symbol to the function block in the application
configuration that protects or controls the object.
•
Use stateColorMap to specify colors for the different states of the
symbol.
1MRS759117 A
REX640
Engineering Manual