Inverter Settings Related To The Easy Sequence Function - Hitachi SJ700-2 Series Instruction Manual

6.1 Inverter Settings Related to the Easy Sequence Function

The following table lists the inverter settings related to the easy sequence function.
Category
Operation
Selection of easy sequence function
switching
Program run signal
General-purpose input
contacts (8 contacts)
General-purpose
output contacts (6
contacts)
Input/
output
switching
General-purpose
analog inputs
(3 terminals)
General-purpose
analog outputs
(3 terminals)
Frequency command selection
Command
Operation command selection
switching
Acceleration/deceleration input selection
Other User-defined variables (32 variables)
Item
Terminal name
PRG (FW terminal)
Intelligent input
terminals 1 to 8
Intelligent output
terminals 11 to 15
Intelligent relay output
terminals AL0 to AL2
O terminal
OI terminal
O2 terminal
FM terminal
AM terminal
AMI terminal
6 - 1
Chapter 6 Interface with the Inverter
Variable notation Related function
in program code
- A017
- A017
X (00) to X (07)
C001 to C008
Xw
C021 to C025
Y (00) to Y (05)
Yw
C026
XA (0)
XA (1)
XA (2)
YA (0) C027
YA (1) C028
YA (2) C029
SET-Freq A001
FW, RV
A002
STA, STP, F/R
ACCEL
P031
DECEL
U (00) to U (31) P100 to P131
Variable/
terminal use condition
-
The PRG terminal is
enabled when A017 = 01.
(The FW function is
disabled.)
Function code settings are
required.
-
- No setting is required.
-
Function code settings are
required.
Related variables are valid
only when A001 = 07.
Related variables are valid
only when A002 = 01.
Related variables are valid
only when P031 = 03.
The variables can be
redefined by using the
digital operator or EzSQ.