Tuning A Station; Setting The Alarm Clock - Silvercrest SWE 100 B1 User Manual And Service Information

Multi-Band Tuner SWE 100 B1

Tuning a Station

 Power the device on.
 Use the volume adjustment button [24] to set the desired sound
volume.
 First select the desired frequency band. To do this, use the band
selector [2]. The currently tuned frequency band will show on the
display [7].
 Fully extract the telescopic antenna [1].
 Rotate the frequency dial knob [23] to tune the desired frequency. The
frequency displays in MHz (for FM and SW) and in kHz (for MW). If
required, move the telescopic antenna into a different position or move
the device to optimise reception of the current station.

Setting the Alarm Clock

Make sure that the clock has been set correctly (see the page 17 - Setting
the Time). The alarm time can only be set while the device is powered off.
If it is still powered on, press the On/Off button [8] to power the device
off.
18 - English
You can only pivot the telescopic antenna and not retract
it into the device housing, otherwise you risk seriously
damaging your device.