Sleep Timer; Setting The Alarm - Silvercrest SWDR 500 B1 Operating Instructions And Safety Instructions

However, you can always use the "MONO" setting if you want. To do so, in
radio mode, press the "MODE" button (15) twice and then use the "TUNE-"
(13) or "TUNE+" (11) button to select between the "MONO" and "AUTO-ST"
settings. The setting made here will prevail until you change it again.

SLEEP timer

The SLEEP timer function lets you set a countdown time between 10 and 90
minutes. After this time, the multi-band tuner (A) switches off automatically. This
setting can be adjusted in 10-minutes steps. The procedure is as follows:
 Press the "POWER/SLEEP" button (8) to power the device off.
 Hold down the 'POWER/SLEEP' button (8) for approx. one second. The
multi-band radio (A) now switches on and the number 90 (for 90 minutes)
and the 'SLEEP' symbol (32) flash on the display (6).
 Press the "POWER/SLEEP" button (8) as many times as necessary to display
the desired time in minutes (e.g. 40). Each press of the "POWER/SLEEP"
button (8) reduces the number of minutes before power off by 10 minutes.
 The multi-band radio (A) automatically switches off after the selected number
of minutes (e.g. 40) has elapsed.
 While the sleep timer is enabled, the "SLEEP" icon (32) is shown on the
display (6).
 While the sleep timer is enabled, it is still possible to select a different
frequency band, to start a station search, to recall a stored station and to set
the volume.
 You can cancel the enabled sleep timer by switching the device off.

Setting the alarm

You can set up to two alarm times (AL1 and AL2). Verify that the clock displays
the correct time. The alarm time can only be set while the device is powered
off. If it is powered on, press the "POWER/SLEEP" button (8) to power the
device off.
SilverCrest SWDR 500 B1
English - 31