Mitsubishi Electric MELIPC MI5000 Series User Manual page 164

Mounting and unmounting of the terminal block
When unmounting the terminal block, use a flat head screwdriver to loosen the terminal block mounting screws.
When mounting the terminal block, tighten the terminal block mounting screws.
• Terminal block mounting screw tightening torque: 0.2 to 0.3 N⋅m
Precautions
Failure to securely fix this may result in drops, short-circuit, or malfunction.
Power wiring end processing
Use a bar solderless terminal for power wiring to insert into the I/O connector.
1.
Strip 10 mm insulation from the tip of the power wiring.
10mm
2.
Connect a bar solderless terminal to the stripped part of the cable.
When attaching the bar solderless terminal, use a crimping tool that meets the solderless terminal manufacturer
specifications.
APPX
162
Appendix 10 Wiring