10.2 Electrical And Mechanical Specifications - Mitsubishi Electric MELSEC iQ-R Series User Manual

Section 10 SPECIFICATION

10.2 Electrical and mechanical specifications

Item
Consumed Voltage
VA circuit
Current
circuit
Internal current
consumption (5 V DC)
Operating temperature
Operating humidity
Storage temperature
Storage humidity
Operating altitude
Installation area
Operating environment
Vibration resistance
Impact resistance
Over voltage category
Pollution degree
Equipment category
Applicable wire
(Usable electric wire)
Tightening torque
Commercial frequency
withstand voltage
Insulation resistance
Standard
*6
Dimensions
Mass
*1: 0 - +50°C (complies with UL standard)
*2: If this modules mounted on the extended temperature range base unit, the same performance as the
used in an operating temperature of 0 to 55 is provided even in an operating temperature of 0 to 60.
*3: At the connection between the secondary terminal of current sensor (k, l) and the main module terminal
(1k, 1l, 3k, 3l), use twisted pair cable.
*4: If stranded wire is used, a bar terminal must be used.
Recommended bar terminal: TGV TC-1.25-11T (Made by Nichifu)
*5: The module can be fixed easily to the base unit, using the hook on top of the module. However, if it is
used under a vibrating environment, we strongly recommend that the module be fixed with screws.
*6: When combine this module with a CT (Model: EMU2-CT5, EMU-CT50, EMU-CT100, EMU-CT250, EMU-
CT400-A, EMU-CT600-A), it becomes UL standard.
Each phase 0.1 VA (at 110 V AC), Each phase 0.2 VA (at 220 V AC)
Each phase 0.1 VA (secondary side of current sensor)
0.45 A
*1 *2 0 – 55°C (Average daily temperature 35°C or below)
5 – 95% RH (No condensation)
-25° – +75°C
5 – 95% RH (No condensation)
2000m or below
Inside a control panel
No corrosive gas
Conforms to Frequency
JIS B 3502,
IEC 61131-2
5 – 8.4Hz
8.4 – 150 Hz
Conforms to JIS B 3502, IEC 61131-2 (147m/s
III or less
2 or less
Class Ι
Single wire
Stranded wire
*3 *4
Module-fixing screws (M3 screw)
Between voltage/current input terminals - sequencer power source and GND
terminals 2210 V AC 5 sec
5 MΩ or more (500 V DC) at locations above
EMC: EN61131-2:2007, EN61326-1:2013
LVD: EN61131-2:2007, EN61010-1:2010
UL61010-1：3 Edition
rd
27.8 mm (W) x 106 mm (H) x 107.1 mm (D) excluding protruding portions
0.2 kg
Specifications
Constant
acceleration
-
9.8 m/s
2
AWG24 – AWG16 (φ 0.52 - 1.29 mm)
AWG20 – AWG16 (0.52 - 1.30 mm
0.36 – 0.48 N・m
*5
146
RE81WH
Half Sweep time
amplitude
3.5 mm XYZ
each direction
-
10 times
, XYZ each direction 3 times)
2
)
2