Siemens SINUMERIK 840D sl Function Manual page 14

Table of contents
8.8 Programmable output duration.............................................................................................414
8.9 Auxiliary function output to the PLC.....................................................................................415
8.10 Auxiliary functions without block change delay....................................................................416
8.11 M function with an implicit preprocessing stop.....................................................................417
8.12 Response to overstore.........................................................................................................417
8.13 Behavior during block search...............................................................................................418
8.13.1 Auxiliary function output during type 1, 2, and 4 block searches.........................................418
8.13.2 Assignment of an auxiliary function to a number of groups.................................................420
8.13.3 Time stamp of the active M auxiliary function......................................................................421
8.13.4 Determining the output sequence........................................................................................421
8.13.5 Output suppression of spindle-specific auxiliary functions...................................................423
8.13.6 Auxiliary function output with a type 5 block search (SERUPRO).......................................426
8.13.7 ASUB at the end of the SERUPRO......................................................................................431
8.14 Implicitly output auxiliary functions.......................................................................................437
8.15 Information options...............................................................................................................438
8.15.1 Group-specific modal M auxiliary function display...............................................................439
8.15.2 Querying system variables...................................................................................................440
8.16 Supplementary conditions....................................................................................................442
8.16.1 General constraints..............................................................................................................442
8.16.2 Output behavior....................................................................................................................443
8.17 Examples.............................................................................................................................444
8.17.1 Extension of predefined auxiliary functions..........................................................................444
8.17.2 Defining auxiliary functions..................................................................................................446
8.18 Data lists..............................................................................................................................450
8.18.1 Machine data........................................................................................................................450
8.18.1.1 NC-specific machine data....................................................................................................450
8.18.1.2 Channelspecific machine data.............................................................................................450
8.18.2 Signals.................................................................................................................................451
8.18.2.1 Signals to channel................................................................................................................451
8.18.2.2 Signals from channel............................................................................................................451
8.18.2.3 Signals to axis/spindle..........................................................................................................453
8.18.2.4 Signals from axis/spindle.....................................................................................................454
9 K1: Mode group, channel, program operation, reset response................................................................455
9.1 Product brief.........................................................................................................................455
9.2 Mode group..........................................................................................................................457
9.2.1 Mode group stop..................................................................................................................460
9.2.2 Mode group reset.................................................................................................................460
9.3 Mode types and mode type change.....................................................................................461
9.3.1 Monitoring functions and interlocks of the individual modes................................................466
9.3.2 Mode change.......................................................................................................................466
9.4 Channel................................................................................................................................467
9.4.1 Global start disable for channel............................................................................................470
9.5 Program test.........................................................................................................................471
9.5.1 Program execution without setpoint outputs........................................................................471
14
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions