Supplementary Conditions; Compressor Functions (Compon, Compcurv, Compcad); Block Search Type 5 (Serupro); Description Of The Function - Siemens SINUMERIK 840D sl Function Manual

9.7.6

Supplementary conditions

9.7.6.1

Compressor functions (COMPON, COMPCURV, COMPCAD)

● If the target block for block search type 2 or type 4 (block search with calculation to ...) is
in a program section in which a compressor function (COMPON, COMPCURV, COMPCAD) is
active, positions are approached on the path calculated by the compressor on repositioning.
These positions must precisely match the positions on the path programmed in the part
program.
● If programmed blocks are eliminated from the part program during compression, these
blocks will not be found at the target block in the block search ⇒ Alarm 15370 "Search target
not found."
9.8

Block search Type 5 (SERUPRO)

9.8.1

Description of the function

Block search type 5, block search with calculation in the "Program test" mode (SERUPRO,
"Search-Run by Program test") enables a cross-channel block search with calculation at a
selectable interruption point. Taking into account existing program coordination commands,
all the status data required to continue the program in the interrupted channels is determined
during SERUPRO and then the NC and PLC set to a state permitting the program continuation.
Before repositioning with subsequent continuation of the program execution, all the output
states that may still be required can be automatically generated via a user-specific ASUB.
Channels
In combination with the HMI, SERUPRO is provided for the following channels:
● For the current SERUPRO channel only (1)
● For all channels with the same workpiece name as the SERUPRO channel (2)
● For all channels with the same mode group as the SERUPRO channel (3)
● For all channels of the NCU (4)
The scope of channels for SERUPRO is selected by means of configuration file maschine.ini,
in Section [BlockSearch]:
Section [BlockSearch]
SeruproEnabled=1
SeruproConfig=1
All other channels started with SERUPRO are operated in "Self-Acting SERUPRO" mode.
Only the channel in which a target block has been selected can be started with a block search
in SERUPRO mode.
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
K1: Mode group, channel, program operation, reset response
Enable search function for HMI and select search configuration
;SERUPRO softkey available for HMI. Default value is (1)
;Number (1) to (4) of above indicated channel grouping. Default value is (1)
9.8 Block search Type 5 (SERUPRO)
493