Huawei CX320 User Manual page 108

CX320 Switch Module
User Guide
Step 2 Configure an FTP server. For details, see
Step 3 Log in through the serial port or SOL, and run the following command on the Ethernet
switching plane CLI:
<HUAWEI>system-view
[~HUAWEI]interface MEth 0/0/0
[~HUAWEI-MEth0/0/0]display this
l
l
Step 4 (Optional) After logging in to the Ethernet switching plane by using a serial port or the Serial
over LAN (SOL) function, run the following commands on the switching plane CLI to query
and set the IP address of the management network port so that the switch module can properly
communicate with the FTP server:
<HUAWEI>system-view
[~HUAWEI]interface MEth 0/0/0
[~HUAWEI-MEth0/0/0]ip address 192.168.100.123 24
[~HUAWEI-MEth0/0/0]commit
[~HUAWEI-MEth0/0/0]display this
#
interface MEth0/0/0
ip address 192.168.100.123 255.255.255.0
#
return
[~HUAWEI-MEth0/0/0]quit
[~HUAWEI]quit
Obtain logs.
Step 5 Obtain logs.
1.
<HUAWEI>system-view
Enter system view, return user view with return command.
[~HUAWEI]diagnose
Issue 09 (2019-08-02)
NOTE
Skip this step if you log in to the switch module by using a network port.
If the command output is as follows with no IP address, go to
#
interface MEth0/0/0
#
return
If the command output contains the IP address and gateway information, go to
#
interface MEth0/0/0
ip address 192.168.100.123 255.255.255.0
#
return
NOTE
Skip this step if you log in to the switch module by using a network port.
View the log file system.
Copyright © Huawei Technologies Co., Ltd.
6.8 Configuring an FTP
6 Common Operations
Server.
Step 5.2.
Step 5.3.
102