Adding A User - Huawei CX320 User Manual

CX320 Switch Module
User Guide
l
Step 4 Enter the new password again.
If the following information is displayed, the initial user password is successfully changed.
Set user password successfully.
----End

4.7 Adding a User

Add a user in the converged switching plane of the CX320. The new user can log in to the
command-line interface (CLI) of the converged switching plane, and allocate operation
permissions to it based on actual requirements, to carry out routine maintenance.
Table 4-7
Table 4-7 Command levels
Command
Level
0
1
2
3
Prerequisites
Data
Issue 09 (2019-08-02)
– Lowercase letters a to z
– Digits 0 to 9
Cannot be the same as the user name or the user name in reverse order.
describes the command levels of the converged switching plane.
Level Name
Visit level
Monitoring
level
Configuration
level
Management
level
Copyright © Huawei Technologies Co., Ltd.
Description
Network diagnosis tool commands (such as ping and
tracert) and external device access commands
System maintenance commands, such as display.
NOTE
Not all display commands are on the monitoring level. For
details about the command levels, see the
Module V100R001 Command
Service configuration commands, including router
commands and the commands at different network
layers. The commands are used to provide direct
network services to users.
Commands of the management level are used for
basic system running to support services, for
example, file system commands, FTP commands,
Trivial File Transfer Protocol (TFTP) commands,
commands for switching configuration files,
commands for managing users, commands for setting
command levels, commands for setting internal
system parameters, and debugging commands for
diagnosing service faults.
4 Configuring the CX320
CX320 Switch
Reference.
69