Restoring The Configuration File - Huawei CX320 User Manual

CX320 Switch Module
User Guide
This topic describes how to restore the configuration file to the CX320. If configuration errors
occur or the CX320 is faulty, you can use the backup configuration file to restore
configuration data.
Use one of the following methods to back up the converged switching plane configuration
file:
l
l
Procedure
Step 1 Log in to the converged switching plane command-line interface (CLI).
Step 2 Log in to the MM910 CLI.
Step 3 Restore the converged switching plane configuration file.
1.
Issue 09 (2019-08-02)
5

Restoring the Configuration File

Power on the converged switching plane to automatically use the configuration file in the
MM910 to restore configuration data. This topic does not describe the automatic
restoration.
Upload and load the configuration file of the converged switching plane to the MM910
and restart the converged switching plane. The system automatically uses the
configuration file of the MM910 to restore configuration data. For details, see the
following procedures in this topic.
Connect the Ethernet port on a PC to the MGMT network ports on the panels of the
active and standby MM910 over a local area network (LAN).
– If the MGMT port on the active MM910 is already connected with a network cable,
do not remove the network cable from the MGMT port. Otherwise, an active/standby
switchover of the MM910s will be triggered, which may cause network interruption.
– If you want to connect your local PC directly to the MM910 using a network cable
but the MGMT port on the active MM910 is already connected with a network cable,
connect the network cable from the local PC to the STACK port of the active
MM910 in the chassis. If the STACK port on the active MM910 is also used, connect
the network cable to an idle STACK port on an active MM910 in a chassis cascaded
with the E9000 chassis.
Copyright © Huawei Technologies Co., Ltd.
5 Restoring the Configuration File
79