Configuration Commands; E-Enable Command Echo; Command Syntax; Description - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
3.1 E–Enable Command Echo

3.1.1 Command Syntax

Command
E[<value>]

3.1.2 Description

This command is used to set whether MS will echo the characters received from TE.

3.1.3 Defined Values

<value>:
0: MS does not echo the characters received from TE.
1: MS echoes the characters received from TE (default value).
If no <value> is included, it is equivalent to the effect that the <value> is 1.
Note:
Issue 04 (2013-01-28)
3
After boot up, the value will be 1 by default.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

Configuration Commands

Possible response(s)
<CR><LF>OK<CR><LF>
Configuration Commands
26