Stripusb-Shield Usb Communication; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
7.5 ^STRIPUSB–Shield USB Communication

7.5.1 Command Syntax

Command
^STRIPUSB[=<strip
usb_status>]
^STRIPUSB?
^STRIPUSB=?

7.5.2 Description

The SET command is used to shield the USB communication. The command is
supported only in UART port. If the parameter is omitted, the default value is 1. If the
value is 0, restore the USB communication (Reserved, not supported currently). Only
support restoring the USB communication through resetting module.
The READ command returns the parameters value.
The TEST command returns the value range it supports.
Note:

7.5.3 Defined Values

<stripusb_status>:
0: Restore USB communication (reserved, not supported currently).
1: Shield USB communication.
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>OK<CR><LF>
In case of an MT-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>^STRIPUSB:<stripusb_status><CR><LF>
<CR><LF>OK<CR><LF>
<CR><LF>^STRIPUSB:(list of supported
<stripusb_status>s)<CR><LF>
<CR><LF>OK<CR><LF>
If this command is sent before the asynchronous command processing is complete, the
command could not be sent.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Security Commands
110