Huawei MU509 At Command Interface Specification page 79

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
select this
TP-DCS
mode)
<TP-UDL>: number of bytes occupied by the "user data" domain. If the value is 0, the
"User data" domain does not exist.
<TP-UD>: the "user data" domain may include "user data header". If it includes the
header (namely, the value of bit6 in byte0 is 1), the value of TP-UDL is equal to the
length filled in the "User-Data-Header" plus the length of "User-Data". The value of
TP-UDL depends on the specific coding mode. If it is a 7-bit default code, it indicates
that there are a total of how many septets; if it is a 8-bit code, it indicates there are a
total of how many Octets; if it is a UCS2 code, the TP-UDL still means a total of how
many Octets; if there are compressed 7-bit or 8bit or UCS2 codes, the TP-UDL
indicates there are a total of how many Octets after compression. The specific
representation structure in the "User data" domain is shown in the following diagram:
Issue 04 (2013-01-28)
UCS2
code)
bit1~0
(messag
e waiting
type)
bit3
bit2
1111 (TE
does not
select
this
value
either)
bit1~0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
0
With voice message waiting.
0
0
With fax message waiting.
1
1
With E-mail message waiting.
0
1
Message waiting of other unknown types
1
0 Reserved bits, which make no sense.
0 7bit code
1 8bit data
0 Class 0, providing display and reply to SC
0 that the message is received but not stored.
0 Class 1, stored to the MS (i.e., NV), or stored
1 to the SIM card
1 Class 2, for use of SIM only. After storing it,
0 the storage state is returned to the SC.
Class 3, stored to the TE. When the MS
1 receives the message, but has not
1 transmitted it to the TE, it will give a response
to the SC.
79