Clck-Enable And Query Pin; Command Syntax; Description - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
"SC": SIM card PIN
"P2": SIM card PIN2
"AB": Reserved, not supported currently
"AC": Reserved, not supported currently
"AG": Reserved, not supported currently
"AI": Reserved, not supported currently
"AO": Reserved, not supported currently
"IR": Reserved, not supported currently
"OI": Reserved, not supported currently
"OX": Reserved, not supported currently
<oldpwd>,<newpwd>: old password, new password, string type, and maximum length
are specified by the parameter <pwdlength>. Legal characters only include „0‟– „9‟.
<pwdlength>: maximum length of the equipment lock password.
7.2 +CLCK–Enable and Query PIN

7.2.1 Command Syntax

Command
+CLCK=<fac>,<mode>
[,<passwd>[,<class>]]
+CLCK=?

7.2.2 Description

The SET command is used to lock, unlock or interrogate a MT or a network facility
<fac>. Password is normally needed to do such actions. When querying the status of
a network service (<mode>=2) the response line for 'not active' case (<status>=0)
should be returned only if service is not active for any <class>. This command should
be aborted when network facilities are set or interrogated.
Issue 04 (2013-01-28)
Possible response(s)
In case of <mode>=2 and successful execution of
command:
<CR><LF>+CLCK:
<status><CR><LF><CR><LF>OK<CR><LF>
In case of <mode>≠2 and successful execution of
command:
<CR><LF>OK<CR><LF>
In case of MS-related error:
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>+CLCK: (list of supported <fac>s)<CR><LF>
<CR><LF>OK<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Security Commands
105