Clip-Set Calling Line Identification Status; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
<status>:
0: Not active
1: Active
10.3 +CLIP–Set Calling Line Identification Status

10.3.1 Command Syntax

Command
+CLIP[=<n>]
+CLIP?
+CLIP=?

10.3.2 Description

This command refers to the GSM/UMTS supplementary service CLIP (Calling Line
Identification Presentation) that enables a called subscriber to get the calling line
identity (CLI) of the calling party when receiving a mobile terminated call.
The SET command enables or disables the presentation of the CLI at the TE. It has
no effect on the execution of the supplementary service CLIP in the network.
The READ command is used to return the current value of parameter <n> and
parameter <m>.
The TEST command is used to return the supported values as compound value.

10.3.3 Defined Values

<n> (parameter sets/shows presentation status to the TE):
0: Disable (default value)
1: Enable
<m> (parameter shows the subscriber CLIP service status in the network):
0: CLIP not provisioned
1: CLIP provisioned
2: Unknown (e.g. no network, etc.)
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CME ERROR: <err><CR><LF>
<CR><LF>+CLIP: <n>,<m><CR><LF><CR><LF>OK<CR>
<LF>
<CR><LF>+CLIP: (list of supported <n>s)<CR><LF><CR>
<LF>OK<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Supplementary Service Commands
149