Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification

6.3.3 Defined Values

<mode>: set the message notification mode.
0: Buffer the message in the ME. If the buffer of ME is full, the new notification will
overwrite the old notification (default value).
1: Send the message notification to the TE directly. When it is impossible to send the
notification (e.g. when in the online data mode), the notification will be discarded.
2: Report the message notification and message state report to the TE directly. When
it is impossible to send them (e.g. when in the online data mode), the message
notification will be buffered in the ME, and will be sent to the TE at a time later
(reserved, not supported currently).
Note:
<mt>: set the rules of storing and notifying the received messages. New messages
can be stored and notified in the following four modes:
0: No SMS-DELIVER indications are routed to the TE (default value).
1: If SMS-DELIVER is stored into MS, indication of the memory location is routed to
the TE.
+CMTI: <mem>,<index>
2: If SMS-DELIVER is not stored into MS, SMS-DELIVERs are routed directly to TE.
<CR><LF>+CMT: [<reserved>], <length><CR><LF><pdu>
3: Class 3 SMS-DELIVERs are routed directly to TE using unsolicited result codes
defined in <mt>=2. Messages of other data coding schemes result in indication as
defined in <mt>=1.
Issue 04 (2013-01-28)
The message notifications are buffered in the volatile storage. If the MS is powered off before
sending the message, the message will probably be lost. Therefore, in case of <mode>=0 or 2,
it is not allowed to use direct forwarding of message (<mt>=2 and 3).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
67