Cdsi-Report New Message State Report; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
6.6 +CDSI–Report New Message State Report

6.6.1 Command Syntax

Command

6.6.2 Description

This command indicates that a new message state report is received, and specify the
storage position.
Note:

6.6.3 Defined Values

<mem>: currently, only "SR" is supported.
"SR": U(SIM) message storage
<index>: integer value, which indicates the position in the storage.
6.7 +CDS–Report New Message State Report Indication
Directly
6.7.1 Command Syntax
Command
6.7.2 Description
This command indicates that received new message state reports are not stored, but
reported to TE directly.
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>+CDSI: <mem>,<index><CR><LF>
Because "SR" is not supported, +CDSI can be received, but new message state report in "SR"
can‟t be read, will be lost.
Possible response(s)
If PDU mode (+CMGF=0):
<CR><LF>+CDS: <length><CR><LF><pdu><CR><LF>
If TEXT mode (+CMGF=1):
<CR><LF>+CDS:
<fo>,<mr>,<ra>,<tora>,<scts>,<dt>,<st><CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
72