V-Set Me Response Format; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
Note:
3.5 V–Set ME Response Format

3.5.1 Command Syntax

Command
V[<value>]

3.5.2 Description

This command is used to set the format of "result code" and "information response" of
the AT command, including the composition of the header and tail, and the form of the
result code contents. The result code contents may be in the form of numerals or
detailed strings. The following table describes the influence of format setting on the
format of "result code" and "information response". <CR> means S3 character, and
<LF> means S4 character.
Table 3-1 Influence of V parameter on the response format
Information responses
Result codes

3.5.3 Defined Values

<value>:
0: MS sends the abbreviated header and tail, and uses the result code in the numeral
form.
1: MS sends the complete header and tail, and uses the result code in the form of
detailed strings (default value).
If no <value> is included, it is equivalent to the effect that the <value> is 1.
Issue 04 (2013-01-28)
If you want to set <value>=1, you can input "ATS5=001", or "ATS5=1", the result is same.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Possible response(s)
<CR><LF>OK<CR><LF>
V0
<text><CR><LF>
<numeric code><CR>
Configuration Commands
V1
<CR><LF><text><CR><LF>
<cr><LF><verbose
code><CR><LF>
29