Description; Defined Values; Cmms-Send More Messages; Command Syntax - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification

6.16.2 Description

The SET command is used to set the message bearer domain, namely, selection of
CS/PS domain.
The READ command returns the current message bearer domain.
The TEST command returns the supported parameter values.
<service> is stored in NV when the command executed, and is restored from NV
when power on.

6.16.3 Defined Values

<service>:
0: PS domain only
1: CS domain only (default value)
2: Prefer the PS domain
3: Prefer the CS domain
6.17 +CMMS–Send More Messages

6.17.1 Command Syntax

Command
+CMMS[=<n>]
+CMMS?
+CMMS=?
6.17.2 Description
The SET command controls the continuity of SMS relay protocol link. When feature is
enabled (and supported by network) multiple messages can be sent much faster as
link is kept open.
The TEST command returns supported values as a compound value.
6.17.3 Defined Values
<n>:
0: Disable (default value)
1: Keep enabled until the time between the response of the latest message send
command (+CMGS, +CMSS, etc.) and the next send command exceeds 1–5 seconds
Issue 04 (2013-01-28)
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CMMS: <n><CR><LF><CR><LF>OK<CR><LF>
<CR><LF>+CMMS: (list of supported <n>s)
<CR><LF><CR><LF>OK<CR><LF>
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
100