Huawei CX320 User Manual page 76

CX320 Switch Module
User Guide
Table 4-8 Required data
Name
converged switching plane
Procedure
Step 1 log in to the converged switching plane command-line interface (CLI).
Step 2 On the CLI of the converged switching plane, run the following command to go to the system
view:
<HUAWEI> system-view
The command output is as follows:
Enter system view, return user view with return command.
Step 3 Go to the AAA view.
[~HUAWEI] aaa
Step 4 Add a local user on the converged switching plane.
local-user User name password irreversible-cipher Password
For example, run the following command to set the user name to user123 and the password to
Huawei12#$ in cipher text:
[~HUAWEI-aaa] local-user user123 password irreversible-cipher Huawei12#$
Info: A new user is added.
Step 5 Set the level of the user user123 to 2.
[~HUAWEI-aaa] local-user user123 level 2
Step 6 Set the user access type.
local-user User name service-type { [ terminal | telnet | ftp | ssh ] * | all }
For example, if you want to set the access type of user user123 to SSH, run the following
command:
[~HUAWEI-aaa] local-user user123 service-type ssh
Step 7 Submit the configuration.
[~HUAWEI-aaa] commit
Step 8 Query information about all users and check that the new user is successfully created.
[~HUAWEI-aaa] display aaa local-user
The command output is as follows:
Issue 09 (2019-08-02)
NOTE
The user name must contain at least six characters.
Copyright © Huawei Technologies Co., Ltd.
User Name and
Password Example
l User name: user123
l Password: Huawei12#$
4 Configuring the CX320
Permission Example
Configuration level
70