Panasonic AFP0HC32ET User Manual page 87

Example 11) When specifying the reading of cyclic communication abnormal node table
When the maximum registered node number is "0", only the value of [D] is updated and the values after [D+1] are not
updated.
[S1]... "EIP" [S2]... "ERR" [D]...WR100
Value
WR100
Example 12) When specifying the reading of RUN/IDLE bit monitor (PLC standby flag)
[S1]... "EIP" [S2]... "PLC" [D]...WR200
Value
WR200
WR201 0000 0001 1111 1111
Example 13) When specifying the reading of RUN/IDLE bit monitor (PLC standby flag)
[S1]... "EIP" [S2]... "PLC" [D]...WR200
When the maximum registered node number is "0", only the value of [D] is updated and the values after [D+1] are not
updated.
Value
WR200
 Flag operation
Name
Hold error (R9007)
Latest error (R9008)
6.1 High-level Instructions Used for EtherNet/IP Control
0 Max. registration node number
9 Max. registration node number
RUN/IDLE bit monitor (Node nos. 1 to 9)
Max. registration node number
0
Description
Set when the read area is out of the range.
Set when the read type (S1) is set to an item other than "IPv4" or "EIP".
Set when the target to be read (S2) is set to an item other than "MAC", "CONNECT",
"ALL", "NODE", "NORMAL", "STOP", "ERR" or "PLC".
Set when a combination other than the combinations listed in the restrictions on
combination is specified for the type (S1) and target (S2) to be read.
Set when the unit specified by F469 UNITSEL is not the Ethernet communication.
Set when executed in an interrupt program.
6-9