Siemens SINAMICS S120 Equipment Manual page 167

Article number
DC link/motor connection
Max. conductor cross-sections
- DC link connection (DCP, DCN)
- Motor connection (U2, V2, W2)
- PE connection
Max. cable length
Degree of protection
Dimensions
- Width
- Height
- Depth
Frame size
Weight
Recommended fuse acc. to IEC
- Number per phase (connected in parallel)
- Rated current
- Frame size acc. to IEC 60269
Recommended fuse acc. to UL
Type 3NE3
Number per phase (connected in parallel)
- Rated current
- Frame size acc. to IEC 60269
Type 3NB1/3NB2
- rated current
Rated power of a typical 6-pole standard induction motor based on I
1)
Rated power of a typical 6-pole standard induction motor based on I
2)
The specified power loss is the maximum value at 100% utilization level. The value in normal operation is lower.
3)
This value applies to the water coolant option; for other coolant types, see Chapter "Cooling circuit and coolant proper-
4)
ties".
To achieve a UL-approved system, it is absolutely essential to use the fuse types specified in the table.
5)
When using fuses connected in parallel in each phase, if one fuse ruptures, then all of the fuses must be replaced.
6)
The short-time current for low overload must be reduced from 150 % to 130 % for 10 s. The short-time current for high
7)
overload must be reduced from 160 % to 130 % for 10 s - and from 150 % to 130 % for 60 s. Otherwise, the duty cycle
remains unchanged.
Water-cooled chassis power units for common cooling circuits
Manual, 08/2017, 6SL3097-4AM10-0BP0
6SL3325–
mm²
mm²
mm²
m
mm
mm
mm
kg
A
5)
A
A
1TG41–3AA7 1TG41-6AA7
7) 7)
Flat connection for M12 screw
Busbar Busbar
Busbar Busbar
Busbar Busbar
300 (shielded) / 450 (unshielded)
IP00 IP00
295 295
1510 1510
545 545
JXL JXL
230 240
3NE3340-8 3NE3337-8
2 3
6) 6)
900 710
2 2
3NE3340-8
2
6)
900
2
3NB2364- 3NB2366-
4KK17 4KK17
2100 2400
or I at 500 or 690 V 3 AC 50 Hz.
L H
or I at 575 V 3 AC 60 Hz.
L H
Motor Modules
6.6 Technical specifications
167