Installing The Controls - Toro Greensmaster Flex 18 Installation Instructions Manual

5

Installing the Controls

Parts needed for this procedure:
1 Traction bracket
1 Throttle lever
1 Spring
Procedure
1. Install the new traction bracket to the handle
using the previously removed hardware
15).
Note:
If the original traction bracket was
attached to the machine through 2 holes in the
handle, order Part No. 112-9318 and 110-2415
to complete the installation.
2. Install the previously removed handle assembly.
Note:
Refer to the handle assembly removal
and reverse the steps for installation.
3. Install the previously removed traction lever and
cable with the previously removed fasteners
(Figure 15).
Important:
The installation is similar to the
installation on the removed bracket; refer to
the previous removal instructions
4. Install the proximity switch to the traction bracket
using the previously removed fasteners; ensure
that the distance between the top of the sensor
and the bottom of the traction handle is within
6/100 to 9/100 inches
Note:
Use the rear holes for proximity switch
installation.
(Figure
(Figure
(Figure 11).
1. Nut
2. Spacer
5. Install and adjust the interlock switch according
to the instructions in your Operator's Manual.
6. Install the new throttle lever to the traction
bracket using the previously removed hardware
(Figure 15).
5).
9
Figure 11
3. Proximity switch (sensor
up)
4. Bolt
g274781