Grooving Cycle - Cycle93 - Siemens SINUMERIK 840D Programming Manual

4
03.96
09.01
4.3 Grooving cycle – CYCLE93
Programming
CYCLE93 (SPD, SPL, WIDG, DIAG, STA1, ANG1, ANG2, RCO1, RCO2, RCI1, RCI2,
FAL1, FAL2, IDEP, DTB, VARI, _VRT)
Parameters
real
SPD
real
SPL
real
WIDG
real
DIAG
real
STA1
real
ANG1
real
ANG2
real
RCO1
real
RCO2
real
RCI1
real
RCI2
real
FAL1
real
FAL2
real
IDEP
real
DTB
int
VARI
real
_VRT
from SW
6.2 and
higher
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
Starting point in the facing axis (enter without sign)
Starting point in the longitudinal axis
Width of groove (enter without sign)
Depth of groove (enter without sign)
Angle between contour and longitudinal axis
Value range: 0<=STA1<=180 degrees
Flank angle 1: on the side of the groove defined by the starting point
(enter without sign)
Value range: 0<=ANG1<89.999 degrees
Flank angle 2: on the other side (enter without sign)
Value range: 0<=ANG2<89.999
Radius/chamfer 1, outside: on the side defined by the starting point
Radius/chamfer 2, outside
Radius/chamfer 1, inside: on the starting point side
Radius/chamfer 2, inside
Final machining allowance on the base of the groove
Final machining allowance on the flanks
Infeed depth (enter without sign)
Dwell time at base of groove
Type of machining
Value range 1...8 and 11...18
Variable retraction distance from contour, incremental
(enter without sign)
4.3 Grooving cycle – CYCLE93
4
Turning Cycles
4-277