0
11.02
3.15.1 Transfer pocket edge contour - CYCLE74 ............................................................. 3-199
3.16.3 Parameters.............................................................................................................. 3-234
3.16.6 Error messages....................................................................................................... 3-258
3.17.2 Parameters.............................................................................................................. 3-265
3.17.4 Interfaces ................................................................................................................ 3-268
3.17.5 Error messages....................................................................................................... 3-270
Turning Cycles ............................................................................................... 4-271
4.1
General information...................................................................................................... 4-272
4.2
Preconditions................................................................................................................ 4-273
4.3
Grooving cycle - CYCLE93.......................................................................................... 4-277
4.4
Undercut cycle - CYCLE94.......................................................................................... 4-287
4.5
4.6
4.7
Thread cutting - CYCLE97 .......................................................................................... 4-308
4.8
4.9
5.1
General information...................................................................................................... 5-348
5.2
5.3
Overview of cycle alarms ............................................................................................. 5-349
5.4
Messages in the cycles ................................................................................................ 5-355
ã Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) - 11.02 Edition
0
Contents
0-7