Cycle Support In Program Editor (Sw 5.1 And Higher); Menus, Cycle Selection - Siemens SINUMERIK 840D Programming Manual

1
General

1.5 Cycle support in program editor (SW 5.1 and higher)

1.5

Cycle support in program editor (SW 5.1 and higher)

As from SW 5.1, the program editor offers an
extended cycle support for Siemens and user cycles.
Function
The cycle support offers the following functions:
•
Cycle selection via soft keys
•
Input screen forms for parameter assignment
with help displays
•
Online help for each parameter (with MMC 103
only)
•
Support of contour input.
Retranslatable code is generated from the individual
screen forms.

1.5.1 Menus, cycle selection

Explanation
The cycle selection is carried out technology-oriented
via soft keys:
Geometry input via the geometry
Contour
processor or contour definition screen
forms.
Input screen forms for drilling cycles
Drill
and drilling patterns.
Input screen form for milling cycles.
Milling
Input screen forms for turning cycles.
Turning
After confirming the screen form input by clicking OK,
the technology selection bar is still visible.
1-40
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
08.99
© Siemens AG, 2002. All rights reserved