Cycle Support Configuration - Siemens SINUMERIK 840D Programming Manual

1
12.97
09.01
PRESS(HS6)
LS("SK_Cycles1","cycproj1")
END_PRESS
A detailed description of the configuration is given in:
References:
With HMI Embedded, make the entry in file
common.com to activate this soft key as follows:
%_N_COMMON_COM
;$PATH=/_N_CUS_DIR
...
[MMC_DOS]
...
SC315=AEDITOR.COM
SC316=AEDITOR.COM

1.6.3 Cycle support configuration

Function
The soft key bars and input screen forms of cycle
support can be configured in any files and stored as
type *.com in the HMI of the control.
A detailed description of the configuration is given in:
References:
In HMI Advanced, the *.com files are stored in data
management in the directories:
•
dh\cst.dir
•
dh\cma.dir or
•
dh\cus.dir
and the usual search sequence is followed:
cus.dir, cma.dir, cst.dir. The files are not loaded into the
NCU.
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1.6 Cycle support for user cycles (SW 6.2 and higher)
/IAM/ HMI/MMC Installation and
Start-Up Guide
BE1 "Expand the Operator Interface"
/IAM/ HMI/MMC Installation and
Start-Up Guide
BE1 "Expand the Operator Interface"
; operating a soft key loads the soft key bar from ;
; file cycproj1.com
1
General
1-49